Imaging System Specifications

Laser Source

The LICORbio Atlas Imager is a Class 1 laser product.

Laser Source Maximum Laser Output Beam Divergence
375 nm 70mW 0.075°
488 nm 30 mW 0.038°
520 nm 55 mW 0.046°
640 nm 210mW 0.075°
685 nmnm 450 mW 0.085°
785 nm 1.2 W 0.060°

Note: The laser beams are approximately collimated.

Note: Actual power output is significantly lower than the maximum power ratings.

Strong Electromagnetic Fields

Operating the LICORbio Atlas Imager in the presence of a strong electromagnetic field in the 100MHz to 400MHz frequency range has been shown to degrade the performance of the luminescent detector. It is possible that some allowable faint bars or striping may be seen at slightly more than the background levels of the camera. When used in the expected environment, this interference should be uncommon.

LED

LED Risk Group: Exempt group in accordance with IEC 62471:2006. The LEDs do not pose any photobiological hazard.

Focus

Focus offset range: -1.00 mm to 5.00 mm, in 0.01 mm increments.

Pixel Resolution

Available imaging resolutions: 5 μm, 10 μm, 20 μm, 50 μm, 100 μm

Maximum Height of Samples

To image an item on the LICORbio Atlas Imager, the item must be 23 mm or less from the Scan Surface to the top of the item. Tall samples could be pushed off the scan surface during imaging and fall into sensitive areas of the instrument that should not come into contact with samples. Special care should be taken with ex vivo samples.

Operating Specifications

Operating Conditions

For indoor use only; operating temperature 15 - 30 °C and dew point not greater than 22 °C, non-condensing; altitude not to exceed 2000 m.

LICORbio Atlas Imager Operating Limits

Figure 86. The light-blue highlighted area indicates the safe operating range for the instrument.

Transport Conditions

Shipping/transport conditions for the LICORbio Atlas Imager should not exceed -40 °C to 65 °C.

Environmental Conditions

Pollution Degree 2

Power Requirements

  • Universal input range is between 100-240 VAC (voltage fluctuations not to exceed 10% of the nominal voltage); < 3 Amp maximum; At 120 V: 0.5 Amp typical when idle; 50-60 Hz.
  • Power Supply: One end of the provided power supply connects to a wall outlet and the other end connects to the imager. The power supply converts from wall outlet voltage to 24 VDC (5 Amp). Only use the provided power supply to plug in the imager. If you need another power supply, contact LICORbio.

Dimensions

  • 24" width × 30" depth × 15" height (61 cm width × 76 cm depth × 38 cm height)

  • Height with lid fully open: 28" (71 cm)

Scan Surface
  • Total Scan Area: 25 cm W × D 18 cm (9.8” W × 7.1” D)

  • Scan Area of Chemi Region: 15 cm W x 11 D cm (5.9” W × 4.3” D)

Dynamic Range

>6 logs for luminescence and fluorescence. This dynamic range is obtained in a single acquisition and maintained in individual image files.

Weight

  • 121 lbs (55 kg)

Network

  • Protocol: TCP/IP
  • Connection: Use the Category 6 network cable provided with the LICORbio Atlas Imager.

Detectors

  • sCMOS image sensor

  • Sensor for chemiluminescence: CCD

Light Sources

  • RGB LED (trans-illumination)

  • RGB LED (reflective illumination)

  • Solid-state diode laser at 375 nm

  • Solid-state diode laser at 488 nm

  • Solid-state diode laser at 520 nm

  • Solid-state diode laser at 640 nm

  • Solid-state diode laser at 685 nm

  • Solid-state diode laser at 785 nm

Optical Information

Laser line-scan imaging module with mirror-based, aberration-corrected optics.

  • Numerical aperture (NA): 0.15

  • Magnification: 1×

Atlas Detection Channel Summary

Excitation / Illumination Emission Filter Atlas Channel
785 nm 816 - 840 nm 785Ex-820Em
685 nm 721 - 740 nm 685Ex-720Em
685 nm 816 - 840 nm 685Ex-820Em
640 nm 664-704 nm 640Ex-680Em
640 nm 721 - 740 nm 640Ex-720Em
640 nm 816 - 840 nm 520Ex-820Em
520 nm 570 - 610 nm 520Ex-590Em
520 nm 520-704 mm 520Ex-680Em
520 nm 721 - 740 nm 520Ex-720Em
520 nm 816 - 840 nm 520Ex-820Em
488 nm 519 - 543 nm 488Ex-530Em
488 nm 570 - 610 nm 488Ex-590Em
488 nm 520-704 mm 488Ex-680Em
488 nm 721 - 740 nm 488Ex-720Em
488 nm 816 - 840 nm 488Ex-820Em
375 nm 417-477 nm 375Ex-460Em
375 nm 519 - 543 nm 375Ex-530Em
375 nm 570 - 610 nm 375Ex-590Em
375 nm 520-704 mm 375Ex-680Em
375 nm 721 - 740 nm 375Ex-720Em
375 nm 816 - 840 nm 375Ex-820Em
NA NA Chemi
470 525 630 Epi NA RGBEpi
631 - 659 nm Clear Window 630Epi
500 - 530 nm Clear Window 525Epi
447 - 472 nm Clear Window 470Epi
470 525 630 Trans NA RGBTrans
631 - 659 nm Clear Window 630Trans
500 - 530 nm Clear Window 525Trans
447 - 472 nm Clear Window 470Trans