Odyssey M Specifications

Imaging System Specifications

Unless otherwise specified, the following apply to Odyssey M Model 3350 and Odyssey M Model 3340.

Laser Source

The Odyssey M is a Class 1 laser product.

Laser Source Maximum Laser Output Beam Divergence
488 nm 30 mW 0.038°
520 nm 50 mW 0.046°
685 nm 450 mW 0.085°
785 nm 1.2 W 0.060°

Strong Electromagnetic Fields

Operating the Odyssey M in the presence of a strong electromagnetic field in the 100MHz to 400MHz frequency range has been shown to degrade the performance of the chemiluminescent imager. It is possible that some allowable faint bars or striping may be seen at slightly more than the background levels of the camera. When used in the expected environment, this interference should be uncommon.

LED

LED Risk Group: Exempt group in accordance with IEC 62471:2006. The LEDs do not pose any photobiological hazard.

Focus

Focus offset range: -1.00 mm to 5.00 mm

Pixel Resolution

Available imaging resolutions: 5 μm, 10 μm, 20 μm, 50 μm, 100 μm

Resolution for chemi images: 100 μm

Maximum Height of Samples

To image an item on the Odyssey M, the item must be 23 mm or less from the Scan Surface to the top of the item. Tall samples could be pushed off the scan surface during imaging and fall into sensitive areas of the instrument that should not come into contact with samples. Special care should be taken with ex vivo samples.

Operating Specifications

Operating Conditions

For indoor use only; operating temperature 15 - 30 °C and dew point not greater than 22 °C, non-condensing; altitude not to exceed 2000 m.

Transport Conditions

Shipping/transport conditions for the Odyssey M Imager should not exceed -40 °C to 65 °C.

Environmental Conditions

Pollution Degree 2

Power Requirements

  • Universal input range is between 100-240 VAC (voltage fluctuations not to exceed 10% of the nominal voltage); < 3 Amp maximum; At 120 V: 0.5 Amp typical when idle; 50-60 Hz.
  • Power Supply: One end of the provided power supply connects to a wall outlet and the other end connects to the imager. The power supply converts from wall outlet voltage to 24 VDC (5 Amp). Only use the provided power supply to plug in the imager. If you need another power supply, contact LICORbio.

Dimensions

  • 24" width × 30" depth × 15" height (61 cm width × 76 cm depth × 38 cm height)

  • Height with lid fully open: 28" (71 cm)

Scan Surface

  • Total Scan Area: 25 cm W × D 18 cm (9.8” W × 7.1” D)

  • Scan Area of Chemi Region (Odyssey M Model 3350 only): 15 cm W x 11 D cm (5.9” W × 4.3” D)

Dynamic Range

>6 logs for chemiluminescence (Model 3350) and fluorescence. This dynamic range is obtained in a single acquisition.

Weight

  • Odyssey M Model 3350: 121 lbs (55 kg)

  • Odyssey M Model 3340: 115 lbs (52 kg)

Network

  • Protocol: TCP/IP
  • Connection: Use the Category 6 network cable provided with the Odyssey M.

Detectors

  • sCMOS image sensor

  • Sensor for chemiluminescence (Model 3350): CCD

Expected Laser Lifetime

  • 685 nm: 20,000 hours

  • 785 nm: 20,000 hours

  • 488 nm: 40,000 hours

  • 520 nm: 40,000 hours

Light Sources

  • RGB LED (trans-illumination)

  • RGB LED (reflective illumination)

  • Solid-state diode laser at 488 nm

  • Solid-state diode laser at 520 nm

  • Solid-state diode laser at 685 nm

  • Solid-state diode laser at 785 nm

Odyssey M Detection Channel Summary

Channel Excitation / Illumination Emission Filter Odyssey M Channel Assay Category / Imaging Mode
800 785 nm 816 - 840 nm 785Ex-820Em Membrane, In-Cell Western (includes On-Cell Western), Cell Analysis, Microscope Slide, Custom
700 685 nm 721 - 740 nm 685Ex-720Em Membrane, Gel, In-Cell Western (includes On-Cell Western), Cell Analysis, Microscope Slide, Custom
700A 685 nm 816 – 840 nm 685Ex-820Em Custom
520 520 nm 570 - 610 nm 520Ex-590Em Membrane, Gel, In-Cell Western (includes On-Cell Western), Cell Analysis, Microscope Slide, Custom
520A 520 nm 721 - 740 nm 520Ex-720Em Custom
520B 520 nm 816 - 840 nm 520Ex-820Em Custom
488 488 nm 519 - 543 nm 488Ex-530Em Membrane, Gel, In-Cell Western, Cell Analysis, Microscope Slide, Custom
488A 488 nm 570 - 610 nm 488Ex-590Em Gel, Custom
488B 488 nm 721 - 740 nm 488Ex-720Em Custom
488C 488 nm 816 - 840 nm 488Ex-820Em Custom
Chemi NA NA Chemi Membrane, Custom (luminescent assays)
RGB Epi 470 525 630 Epi NA RGBEpi Custom
630 Epi 631 - 659 nm Clear Window 630Epi Membrane
525 Epi 500 - 530 nm Clear Window 525Epi Membrane
470 Epi 447 - 472 nm Clear Window 470Epi Custom
RGB Trans 470 525 630 Trans NA RGBTrans Microscope Slide, Custom
630 Trans 631 - 659 nm Clear Window 630Trans Gel, Absorbance Assay
525 Trans 500 - 530 nm Clear Window 525Trans Custom
470 Trans 447 - 472 nm Clear Window 470Trans Gel, Absorbance Assay